- Years of Manufacture: 1967 - 1969
- Number Built: 9,002
- Price at Introduction:
- To Identify:
- Raised "power bulge" on bonnet
- Power bulge accentuated by transverse chrome strip
- Body:
- Exterior Dimensions:
- Total Length: 12ft. 9.2in. (389cm)
- Total Width:
5ft. 0in. (152cm)
- Total Height at kerb weight:
4ft. 2in. (127cm)
- Wheelbase: 7ft. 7in. (231cm)
- Front Track: 4ft. 2in. (127cm)
- Rear Track: 4ft. 1.5in. (126cm)
- Kerb Weight:
- Turning Circle:
- Fuel Tank Capacity:
- Equipment:
- Battery: 12 volt, 58 amp hour. 2 x 6 volt, negative earth
- Alternator: Lucas sealed units, 100/80 watt total
- Reversing lamps: 2 standard
- Electrical fuses: 2
- Screen wipers: 2, self-parking
- Screen washer: Manual plunger standard
- Interior heater: Standard, water valve type
- Heated backlight: Extra on GT only
- Safety belts: Optional extra, however anchorages built-in
- Interior Trim: Leather and PVC trim
- Floor coverings: Rubber mats and carpet
- Jack: Screw pillar
- Jacking points: 1 each side, in centre of body
- Windscreen: Laminated
- Underbody protection: Phosphate treatment prior to painting
|
- 6 cylinder in-line engine:
- Capacity: 2912cc 177.7 cu. in.
- Type: Conventional, watercooled four
stroke, reciprocating piston type with
6 cylinders
- Configuration: Front mounted, longitudinal,
inline
- Head: Pushrod and rocker actuated ohv
with two valves per cylinder
- Fuel System: 2 x SU HS6
- Bore and Stroke: 3.28 x 3.5 inches
(83.4 x 88.9mm)
- Power: 150bhp at 5250rpm
- Torque: 174lb-ft at 3500rpm
- Compression Ratio: 9.0:1
- Ignition and Electrical:
- Cooling System:
- 18.5 pints (inclusive of heater, 10.5 liters)
- Engine Sump:
- 12.8 pints (7.2 liters) SAE 20W/40
- Manufacturer recommended oil change every 6000 miles
- Change filter element every 6000 miles
- Manual Transmission (4 speed - all synchromesh):
- 1st: 3.42:1
- 2nd: 2.14:1
- 3rd: 1.38:1
- 4th: 1.00:1
- Reverse: 3.06:1
- Overdrive:
- Automatic Transmission (3 speed):
- 1st: 2.39-4.81
- 2nd: 1.45-3.04
- 3rd: 1-2:1
- Reverse: 2.09-4.39
- Clutch:
- 9 inch diaphragm single dry plate
- Belleville diaphragm
- Rear Axle Ratio:
- 3.07:1 (3.307 with overdrive or automatic)
- Suspension:
- Front: Independent, torsion bars, telescopic dampers, anti-roll bar
- Rear: Live axle, half elliptic leaf springs, lever-arm dampers
- Long torsion bars for the revised front suspension extend back to mounting points vertically under the seats, where front suspension height can be adjusted
- Steering:
- Rack and pinion, wheel diameter 16.5 inches
- Brakes:
- Girling disc front, drum rear
- Standard vacuum type servo
- Front: 11 inch disc, swept area 226.2 sq. in.
- Rear: 9 inch diameter, 2.5 inch wide shoes, 127.2 sq. in.
- Wheels:
- Pressed steel disc, 5 inch wide rim
- Wire wheels optional
- Tyres:
- Dunlop SP41 tubed radial ply 165 x 15
|